Enzyme Activity Calculator
Find the mass of an enzyme preparation needed for a target activity concentration and final volume.
01 Set up your calculation
- Enter the target enzyme activity per milliliter.
- Enter the preparation’s specific activity in units per milligram.
- Specify the final total volume and read the required preparation mass.
02 The relationship
For the assumptions behind these results, read the explanation below. You can also explore Michaelis–Menten Equation and Solution Dilution.
Follow the numbers
To prepare 10 mL at 8 U/mL from a preparation rated 200 U/mg, the target is 80 U and the mass is 80/200 = 0.4 mg.
03 Activity is an assay-dependent quantity
An enzyme unit commonly represents conversion of one micromole of substrate per minute under specified assay conditions. A preparation’s rated activity therefore belongs to a particular substrate, temperature, pH, and measurement method.
Specific activity in U/mg is activity divided by mass of the stated preparation or protein basis. Check the product or assay definition carefully; U/mL describes a liquid stock concentration and cannot be entered directly as U/mg.
04 Use the same assay basis on both sides
The mass calculation assumes the preparation retains its stated activity in the final conditions. Storage, dilution, inhibitors, and differences between the rating assay and your experiment can change the effective activity.
Final volume means the total prepared volume. The result gives an amount to use within an established experimental protocol; it does not identify a suitable buffer, incubation time, or biological dose. Very small masses may require a calibrated stock solution for accurate transfer.
Questions from the notebook
Is an activity unit the same as enzyme mass?
No. Different preparations can have very different activity per milligram.
Can I enter a liquid stock in U/mL here?
No. This mass calculation needs specific activity in U/mg. Use an activity dilution calculation for a liquid stock.
Can the target be zero?
Yes. Zero desired activity corresponds to zero enzyme mass in this model.
References & reading
- McDonald and Tipton — Parameter Reliability and Understanding Enzyme Function ↗
Defines enzyme units, specific activity, initial-rate conditions, and limitations of Michaelis–Menten parameters.
- NIST — Guide to SI conversion factors ↗
Supports physical unit conversions. Input values are converted to the formula’s base units before calculation.
Our explanations are written for ChemistryCalc. Read how we build and check our tools. These calculations are educational estimates where the underlying model requires assumptions.